Motorhome Tools

The payload check to do before you buy any motorhome

Before you talk price, do two things. Photograph every weight plate on the van. Then ask the seller one question: what does it weigh today, and can I have that in writing?

The plates tell you the most the van is allowed to weigh. The seller’s answer tells you how much of that is already used. The gap is your payload: everything you bring, including yourselves. On many motorhomes that gap is smaller than the brochure suggests, and it is far cheaper to find out on the forecourt than at a weighbridge six months later.

The check in four steps

  1. Photograph the weight plates. Note the maximum weight and both axle limits.
  2. Get today’s weight. A weighbridge ticket is best.
  3. Add your own load in our payload calculator.
  4. Read the result for the whole van and, if you can, for each axle.

Allow about fifteen minutes.

Step 1: Find the weight plate and read it

Every motorhome has a small plate or sticker showing its weight limits. It is often called the VIN plate, because it also carries the vehicle identification number. Look under the bonnet or on the cab door pillar. The handbook will say where.

It normally shows four weights, in this order:

Line Example What it means
First 3,500 kg The most the loaded van may weigh. You will also see this called MAM, MTPLM or gross weight.
Second 6,000 kg The most the van and a trailer may weigh together.
1 – 1,850 kg The most the front axle may carry.
2 – 2,000 kg The most the rear axle may carry.

Example figures only. Use the ones on the van in front of you.

Two things catch people out. The axle limits here add up to 3,850 kg, but the van may still only weigh 3,500 kg: each limit applies on its own, and you must be inside all of them. And if a VIN plate shows only three weights, the industry’s NCC Motorhome Guide 2025, page 10 says the van is not rated to tow. If towing matters, confirm with the maker.

Vehicle weights explained explains the maximum weight.

If you find two or three plates

This is normal. Most motorhomes are built in stages, and each company can fit its own VIN plate:

Here is how to deal with them:

  1. Look for the motorhome maker’s plate first. It will carry their name. The NCC’s 2025 guide says that where this VIN plate differs from the base vehicle or chassis maker’s plate, the motorhome maker’s plate takes precedence. It also gives the axle limits.
  2. Do not treat a chassis plate as the whole van. A chassis maker’s plate may show higher axle figures. That does not raise the maximum for the finished motorhome.
  3. If the motorhome maker’s plate leaves a line blank, do not guess. Note the figure from the earlier VIN plate and ask the motorhome maker, quoting the VIN, to confirm it in writing.
  4. If you cannot tell which VIN plate is which, or the plates and the V5C registration document disagree, give the VIN to the motorhome maker and ask them to confirm the maximum weight and both axle limits in writing.

If nobody can confirm the figures in writing, don’t rely on the higher one. Ask the motorhome maker to confirm, or look at another van.

Has the weight been changed since it was built?

Some vans have had their maximum weight raised or lowered later, often to move them across the 3,500 kg line. If a seller says the van has been re-rated, ask to see the new VIN plate or sticker, the paperwork from whoever did the work, and a V5C that shows the new weight. DVLA asks for a plating certificate or a design weight certificate before it will change the weight on a V5C. Check any re-rating with a specialist before you buy.

The maximum weight is worth getting right. It decides your payload, and it also decides which driving licence you need.

Step 2: Find out what it weighs today

This is the number sellers rarely offer, and the one you most need.

On a used van, look for what has been added since new: awning, solar panels, second leisure battery, towbar, bike rack, satellite dish, air conditioning. All of it comes out of your payload.

No ticket? Ask the seller to weigh the van, or make your offer subject to one. The official find a weighbridge service can help, and our guide to weighing a motorhome explains what to ask for.

Step 3: Add your real load

Open the payload calculator.

  1. Enter the registration. The lookup may fill in the make and the recorded maximum weight. It cannot tell you what the van weighs, and you should check its answer against your VIN plate photos.
  2. Type in both axle limits from the VIN plate.
  3. Check what was on board when the ticket was taken. The calculator’s empty weighbridge box treats the ticket as the van only. If the ticket already includes fuel, set Fuel fill level (%) to only the fuel you will add after weighing, or 0 if adding none. Add only what goes on board after weighing, including people, water, gas, bikes and kit; do not count anything the ticket already includes twice. If you only have the V5C Mass in Service, use that instead and treat the result as an estimate.
  4. Add what you will really carry: passengers, water (one litre weighs one kilogram), gas, bikes and rack, awning, chairs, clothes, food, the dog.

If you would rather not start from a blank page, there are presets for a light weekend with two adults and a full week for a family of four.

A worked example

This is a manual weight calculation, not a set of entries to copy directly into the calculator. The starting ticket already includes fuel, so do not add fuel again. Check what is included in your own ticket before using the calculator.

Item Weight
Maximum weight on the VIN plate 3,500 kg
Weighed today: empty, fuel in the tank, nobody on board 3,050 kg
Two adults 160 kg
Fresh water, 100 litres 100 kg
Two 6 kg gas cylinders, full 26 kg
Two e-bikes and a rack 60 kg
Awning, chairs, table, barbecue 50 kg
Clothes, food, bedding 80 kg
Loaded weight 3,526 kg
Result 26 kg over

Example figures only. Replace every line with your own.

On paper this van had 450 kg to spare before adding people and kit. With two people and a fairly ordinary load it is over the limit. Travelling with 20 litres of water instead of 100 brings it down to 3,446 kg, leaving 54 kg in hand. That might suit you. It would not if you plan to carry a third person or stay off-grid. The calculator’s “What if I empty the water?” button shows the same effect for your own van.

Step 4: Read the result, including each axle

Check three things: the total, the front axle and the rear axle. A van can be inside its total and still overload the rear axle, because anything carried behind the rear wheels, such as a loaded garage or a rack of e-bikes, presses on that axle by more than its own weight.

The calculator can only check the axles if you give it front and rear weights from a weighbridge ticket. That is one more reason to ask for a ticket that shows both. Our guides to axle weights and rear axle overload explain the rest.

Then ask yourself one question. Does the answer only work with an empty water tank and the bikes left at home? If so, the van does not fit the way you travel.

Questions to put to the seller, in writing

  1. What does the van weigh today, and how do you know?
  2. Can I have a weighbridge ticket showing the total and each axle?
  3. What was on board when it was weighed?
  4. What has been fitted since it left the factory?
  5. Has the maximum weight ever been changed? If so, where are the VIN plate and the paperwork?
  6. Do the plates and the V5C show the same maximum weight?

An email is fine. A seller who is confident in the van should not mind.

If the numbers do not work

Already bought it?

The same check works. Weigh the van loaded as you really travel and put the figures in the payload calculator. If any of the terms are new, read MAM, mass in service and payload.

Forecourt checklist

Save this to your phone.

Source checks recorded on 14 November 2026; calculator wording reviewed on 18 November 2026; VIN plate and re-rating guidance reviewed on 19 November 2026. Weight limits are specific to each vehicle. If in doubt, ask the manufacturer.