Quick answer: usually, if you check four things first.
- Overall size: keep the new wheel-and-tyre diameter close to the original. Compare the two tyre sizes from the sidewalls in step 1 of our wheel & tyre checker.
- Hub fit: bolt pattern, centre hole and offset must suit your exact chassis.
- Load: the wheel's "Max Load" (stamped on it or in the maker's certificate) and the tyre's load index must cover both axle limits on your VIN plate.
- Speedometer: a bigger diameter makes it read low.
Then ask the seller for the wheel's load certificate, tell your insurer, and have a qualified fitter confirm clearance and fitting.
Why do owners fit bigger wheels?
For looks, a little more ground clearance or wider tyre choice. One Ducato owner wanted to replace small 15-inch wheels for both reasons. A long-wheelbase Crafter owner hoped to stop the step grounding on ferry ramps.
Clearance only improves if the overall diameter grows, which has knock-on effects. Keep the diameter the same, as usually advised, and ride height barely changes.
What size should I aim for?
Rim size is only part of it. What matters is the overall diameter of the wheel and tyre together. You can estimate it from the sidewall size:
diameter (mm) = rim size × 25.4 + 2 × tyre width × aspect ratio ÷ 100
Worked examples (nominal geometry only):
- 215/70 R15 → 215/65 R16: 682.0 mm → 685.9 mm, about +0.6% (close).
- 215/70 R15 → 225/75 R16: 682.0 mm → 743.9 mm, about +9.1% (a big jump).
- 245/75 R16 → 265/65 R17: 773.9 mm → 776.3 mm, about +0.3% (close).
The usual approach is to go up in rim size and down in tyre profile (Practical Motorhome). Step 1 of the checker does this sum for you. It's geometry only, not the loaded rolling circumference.
Will my speedometer be affected?
If the overall diameter grows, each turn of the wheel covers more road, so the speedometer shows less than your true speed unless it's recalibrated, as Ducato owners discussed. Some guides quote a percentage "safe" limit; we found no official source, so we don't repeat one. Some base vehicles also store the wheel or tyre size in their electronics. Ask a dealer or specialist whether yours needs updating; we can't confirm it for any specific vehicle.
Will the wheels fit my hub?
- PCD (pitch circle diameter) is the size of the circle the wheel bolts sit on. Versions of the same base vehicle can use different patterns, such as light and heavy chassis, so confirm yours.
- Centre bore is the hole in the middle of the wheel that fits over the hub.
- Spigot rings are rings that adapt an aftermarket wheel's centre bore to your hub. Practical Motorhome says the fit must be snug and that spigot rings "support the load of the wheel on the hub". Without them you risk snapping wheel bolts.
- Offset is how far in or out the wheel sits. It's usually stamped on the back of the wheel as "ET" plus a number in millimetres.
- Bolts or nuts: alloys may need different ones from steel wheels.
Will they carry the weight?
- Wheel: with single wheels, each wheel's rating must be at least half the plated limit for its axle. See our guide to wheel load ratings.
- Tyre: the load index is the number before the speed letter on the sidewall, standing for the most weight the tyre can carry. TyreSafe advises never fitting a lower load or speed rating than the originals, and keeping the same size and markings across an axle.
- Tyre type: motorhomes usually leave the factory on C tyres (van tyres built for heavier loads) or CP tyres (a camping version for motorhomes). LT tyres (light-truck tyres, often all-terrain) are sometimes fitted when upsizing. A retailer notes that LT tyres are not C tyres, even when size and load index look alike. Check with the vehicle or tyre maker before switching type.
When you've chosen a pairing, screen it against your VIN-plate axle limits in step 2 of the checker. Missing evidence shows as Unverified, never a pass. It's a screening aid, not approval to fit.
What about weight and clearance?
Larger wheels and tyres can weigh more, and any extra comes off your payload, so check the maker's weights. A bigger diameter can also rub on arches, steps or suspension. One owner's supplier checked that the larger wheels wouldn't foul the wheel guards. Your fitter should confirm clearance on your van.
Do I need to tell my insurer?
Yes. A wheel or tyre size change is generally a modification (Practical Motorhome). One owner was quoted nearly £100 extra for a 16 to 17-inch change; another insurer made no change.
Before you buy: checklist
- Note your current tyre size and both axle limits from the VIN plate.
- Compare overall diameters in the checker and stay close to the original.
- Confirm PCD, centre bore, offset and bolts for your exact chassis.
- Get the wheel's load rating and the tyre's load and speed rating in writing.
- Ask about speedometer and chassis settings.
- Tell your insurer.
- Have a qualified fitter confirm clearance and fitting.